Under the Configuration header of the left navigation, select TCP/IP On newer models the password is the serial number of the printer displayed on the sticker. Select Proceed to 192.168.192.168 (unsafe)Įnter into the Authentication Required or Sign In prompt: Should see a page with message “Your connection is not private” Use a web browser to access the printer's configuration page.Įnter the IP address of the printer (192.168.192.168) into the address bar Set a network configuration to the Printer Select Apply, then connect an ethernet cable from the computer to the Epson TM-U220 printer Select Ethernet or the appropriate adapter (e.g. Use Network Preferences to change the IP configuration of a MacOS computer. Proceed to Set a network configuration to the Printer

Select OK, then connect an ethernet cable from the computer to the Epson TM-U220 printer.

Select Internet Protocol Version 4 (TCP/IPv4) from the list Use the Control Panel to change the IP settings of a Windows computer. The changes made during the configuration process will need to be undone in order to restore normal connectivity. IMPORTANT! Please make a note of your current network settings before making changes. Wait until a small receipt with the below information prints (this can take about 60 seconds) The printer will make a mechanical noise and print a sheet indicating it is in the process of resetting to factory defaults

Turn the printer ON while continuing to hold the Network Status Button Use the tip of a pen or a paperclip to depress and hold the Network Status Button The small black dot below or above the yellow label is the Network Status Button Locate the Network Adapters on the rear underside of the printer. Reset the printer to factory defaults to wipe any existing configurations. It’s always best to start from a clean slate. Use a web browser to access the printer’s configuration interface and set a configuration to the printer Physically connect the computer to the printer with an ethernet cable When in doubt, please contact your Network Management Team with any questions.Ĭhange the computer’s network settings to allow it to communicate with the printer NOTE: Every device on a network must have a unique IP address. An adapter, such as a Thunderbolt Ethernet for Mac, may be requiredĪn IP address available for use by the printer NOTE: Many late-model laptops do not have a physical ethernet port. Having Trouble? See our Tips and Tricks or Contact SALIDO Support.

It may seem a little daunting at first, but the whole process can usually be completed in about ten (10) to twenty (20) minutes. In this article we will review how to change the network configuration of an Epson TM-U220 impact printer.

Driver epson m188b